CB360 Brat Progress

Well the CB360 is almost done. It's been a while since I posted on it so I'll try to catch you up in one shot. I seemed to work out all the small stuff that goes along with building a bike. Got the light mounted and the brakes all sorted out. I needed to tackle a seat so I got out the sheet and started pounding away. got it all pounded out and took it and some ostrich skin I had at the house to a local upholstery shop. They did a killer job and the color really compliments the bike.

Once that was done, I had a horrible time trying to get it running right. After a lot of research I discovered that these bike and carbs really hate to have pod filters and short exhaust. With that in mind, I sent my carbs off to CrazyPJ in Florida to modify the air jets. The problem isn't so much with the volume of air that they are sucking in, but rather the lack of calm air. I still have the cheap pods on but will be upgrading to some better filters soon.

My buddy Dallas stopped by one day and I told him that I really needed a set of mufflers to get the exhaust extended past the rear axle and quiet the beast down. He just happened to have a set of Harley take offs in the back of his truck. A little cutting and welding later and I had them mounted up.

Now that the bike is all together and my pipes and carbs are done, I've been running it a bit and have some new issues. 1. It will surge initially and stay elevated. That may be an advancer issue so I need to check that. 2. It's also hissing some oil out the seal at the kicker. That worries me in that it may not be getting enough oil flow so I'm gonna make sure it's getting oil in the top end, check the breather and replace that seal.

To be continued...